Recall 11V447 affects 119 2011 Multiquip TRLR220XFH and TRLR220XFE trailers for weak axle-hub welds. Repair will be free at any franchised Multiquip dealer once available.
Multiquip is recalling 119 2011 TRLR220XFH and TRLR220XFE dual axle trailers because an incorrect welding procedure left the axle hub assembly with insufficient weld penetration. If the axle breaks while the trailer is in use, crash risk increases; the dealer repair will be free once Multiquip makes it available.
Does this recall apply to your specific vehicle?
The official, free per-VIN recall check is run by NHTSA. Enter your VIN and we'll forward you directly — and add you to a free watchlist so you hear about new recalls for your vehicle.
Check my VIN at NHTSARecallNotify doesn't check your VIN — NHTSA's official tool does. We use your email only to alert you to new recalls.
Watch this vehicle for recalls
Add it to your free watchlist and we will alert you as new federal recalls are posted for your year, make and model. New-recall alerts are rolling out now.
You are on the watchlist.
We will email you as new federal recalls are posted for your vehicle.
What's wrong?
The axle hub assembly on the 2011 Multiquip TRLR220XFH and TRLR220XFE trailers is the connection point between the axle and the wheel end. It supports the wheel, carries trailer load through the axle, and keeps the brake hardware aligned as the trailer rolls. On these trailers, that hub area depends on a welded assembly staying fully bonded to the axle structure.
The recall involves an incorrect welding procedure at that axle hub assembly. The weld did not penetrate deeply enough into the metal, which means the joined parts are not fused as strongly as designed. Under towing loads, vibration, and road impacts, that weak weld area can lose strength and allow the hub assembly to shift or fail.
There is no warning sign before failure. An owner should not count on noise, vibration, or a visible change at the wheel to show that the weld is failing.
Who's affected?
Covers the TRLR220XFH and TRLR220XFE trailer models, both tied to the drive axle.
| 2011 Multiquip TRLR220XFH | drive axle |
|---|---|
| 2011 Multiquip TRLR220XFE | drive axle |
| Units affected | 119 |
A matching 2011 Multiquip TRLR220XFH or TRLR220XFE does not guarantee inclusion. Check your VIN to confirm whether your specific trailer is included.
What's the safety risk?
An axle failure while the trailer is in use increases the risk of a crash. Keep loads and road use conservative until the trailer is inspected, and schedule the axle inspection and any needed replacement soon. Repair will be free at any franchised Multiquip dealer once available.
What should I do?
- Check your VIN to confirm your 2011 Multiquip TRLR220XFH or TRLR220XFE trailer is included in this recall.
- Confirm with Multiquip that the owner notice mailed on August 3, 2011 applies to your trailer before scheduling service.
- Contact Multiquip or Global Direct Components to arrange the axle-hub weld inspection and any needed axle replacement.
- Reference recall number 11V447 when you call so the service contact can match the trailer to the axle assembly recall.
- Avoid using the trailer until the axle-hub weld has been inspected and any axle outside specification has been replaced.
What happens at the repair
Multiquip reported that identified owners were notified on August 3, 2011. The listed repair is an inspection of the trailer axle hub weld by the axle supplier, Global Direct Components. A Multiquip technician or supplier representative measures the weld, checks whether it meets specification, and replaces any axle that falls outside specification. The dealer repair will be free once available, with parts and labor covered under the recall.
Timeline
| August 3, 2011 | Owner notification mailed |
|---|---|
| August 30, 2011 | NHTSA published the recall |
Frequently asked questions
What is recall 11V447?
Recall 11V447 covers 119 2011 Multiquip TRLR220XFH and TRLR220XFE dual axle trailers with an axle hub weld that has insufficient penetration. The axle can break while the trailer is in use, increasing crash risk. Global Direct Components will inspect the weld and replace any axle outside specification.
What should I do if my 2011 Multiquip TRLR220XFH or TRLR220XFE is on this recall?
Check your VIN to confirm your specific trailer is included in recall 11V447. If it is, contact Global Direct Components at 1-574-522-5300 or Multiquip at 1-310-537-3700 to arrange the axle weld inspection and any required axle replacement.
Is the recall repair free?
Yes. Federal recall law requires the recall remedy to be completed at no cost to the owner. For recall 11V447, Global Direct Components will inspect and measure the axle hub weld and replace any axle that is outside specification.
What is the safety risk?
The safety risk is axle breakage while the trailer is in use. Multiquip reported that an incorrect welding procedure left the axle hub assembly with insufficient weld penetration, which can allow the axle to break and increase the risk of a crash.
When were owners notified about recall 11V447?
Multiquip notified all identified owners on August 3, 2011. If you own a used 2011 TRLR220XFH or TRLR220XFE and never received a letter, check your VIN and reference recall 11V447 when contacting Global Direct Components or Multiquip.
More information
| NHTSA campaign page | nhtsa.gov/vehicle-recalls/11V447000 |
|---|---|
| Multiquip customer service | 1-574-522-5300 |
| NHTSA recall # | 11V447 |
| NHTSA recall # (full) | 11V447000 |
Source documents
-
Download Recall Document (PDF) (PDF) - Download Recall Document (PDF) (PDF)
- Download Defect / Noncompliance Notice (PDF) (PDF)
- Download Recall Acknowledgement (PDF)
This article is generated from NHTSA's primary recall filings and reviewed against the source on June 2, 2026. RecallNotify does not paraphrase NHTSA's consequence language; that text is reproduced as written above. Editorial standards →